Worx WG322E Manual Original página 13

in Figure 4, cut 1/3 the diameter from the underside (
underbuck) (1). Then make the finished cut by overbucking
(2) to meet the first cut.
Fig.4
1
1/3
When the log is supported on both ends, as illustrated in
Figure 5, cut 1/3 the diameter from the top (overbuck) (1).
Then make the finished cut by underbucking (2) the lower
2/3 to meet the first cut.
Fig.5
1
1/3
When bucking on a slope always stand on the uphill side of
the log, as illustrated in Figure 6. When "cutting through",
to maintain complete control release the cutting pressure
near the end of the cut without relaxing your grip on the
chain saw handles. Don't let the chain contact the ground.
After completing the cut, wait for the saw chain to stop
before you move the chain saw. Always stop the motor
before moving from tree to tree.
Cordless Chain Saw
Fig.6
2
2/3
SYMBOLS
2
2/3
To reduce the risk of injury, user must
read instruction manual
WARNING
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to rain
Wear protective gloves
Waste electrical products must not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
EN
13