Worx WG322E Manual Original página 21

TROUBLESHOOTING TABLE
The following table gives checks and actions that you can perform if your machine does not operate correctly. If these do not
identify/remedy the problem, contact your service agent. WARNING: Switch off and remove plug from power source
before investigating fault.
Symptom
Chain saw fails to Out of battery.
operate Fuse faulty.
Chain saw Over heating
operates
intermittently Applying too much pressure while cutting.
Loose connection.
Internal wiring defective.
On/Off switch defective.
Dry chain No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Chain/chain bar No oil in reservoir
over-heats Vent in oil filler cap clogged
Oil passage clogged
Chain is over tensioned
Dull chain
Chain saw rips, Chain tension too loose
vibrates, does not Dull chain
saw properly Chain worn out
Chain teeth are facing in the wrong
direction
Cordless Chain Saw
Possible Cause
Charge the battery pack.
Replace fuse.
Place the machine in a cool, ventilated place to
cool it down.
Applying relatively less pressure while cutting.
Contact service agent.
Contact service agent.
Contact service agent.
Refill oil
Clean cap
Clean oil passage outlet
Refill oil
Clean cap
Clean oil passage outlet
Adjust chain tension
Sharpen chain or replace
Adjust chain tension
Sharpen chain or replace
Replace chain
Reassemble with chain in correct
direction
Remedy
21
EN