Sauder Carson Forge 414444 Instrucciones De Montaje página 2

Table of Contents
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Part Identifi cation
å
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
A RIGHT END (1)
B LEFT END (1)
C UPRIGHT (1)
D TOP (1)
E BOTTOM (1)
Page 2
Assembly Tools Required
2-3
4
5-23
24-26
27-29
30
31
F PANEL (2)
G SHELF (1)
H2 RIGHT FRONT/LEFT REAR LEG (2)
I2 LEFT FRONT/RIGHT REAR LEG (2)
J BRACE (1)
414444
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Hammer
Not actual size
Skip the power trip.
This time.
K PANEL MOLDING (2)
L UPPER END MOLDING (2)
M LOWER END MOLDING (2)
N CENTER SUPPORT (4)
www.sauder.com/services