Sauder Carson Forge 414444 Instrucciones De Montaje página 21

Step 17
IMPORTANT: You will need someone's help in this step.
å
Fasten the TOP (D) to the ENDS (A and B). Use two BUSHINGS (91M) and two BLACK 3/4" PAN HEAD SCREWS (85S)
å
through the exact holes shown in the LIFT TABLE MECHANISMS (23M) and into the holes in the ENDS.
NOTE: Do not overtighten the SCREWS (85S).
å
Then, fasten the TOP (D) to the ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S) through the LIFT
å
TABLE MECHANISMS (23M) and into the remaining holes in the ENDS.
NOTE: Be careful when lining up the holes in the MECHANISMS
å
with the holes in the ENDS as to not damage any parts.
You should start each SCREW a few turns
before completely tightening
any of them.
91M
85S
BLACK 3/4" PAN HEAD SCREW
(2 used for the BUSHINGS)
Do not overtighten
the SCREWS (85S).
www.sauder.com/services
23M
A
D
85S
414444
These four holes
23M
must be here.
B
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
91M
1S
Page 21