Trouble Shooting; Maintenance; Mounting & Product Dimensions; Equipment - Carpoint 0635863 Manual De Instrucciones

d) The charger is in recovery mode for over 2 hours.
e) The charger is in bulk and absorption mode for over 41 hours.

trouBLe ShootIng

Charger light does not turn on:
a) Remove the charger from the AC outlet and recheck the charger clamps are connected to the
correct terminals and are making a clean connection.
b) Check to make sure AC outlet is supplying power.
c) A bad connection of the battery to ground.
Charger light is on but battery does not charge properly
a) The battery may be defective or of oversize.
b) The battery has a excessive current draw, battery must be replaced.

maIntenance

This Carpoint charger does not need any specific maintenance. Only install, maintain or service
this charger when it is disconnected from the mains. It may be cleaned with a dry cloth or soft
tissue. Under any circumstances, do not use any solvents or other cleaning agents.
mountIng & Product dImenSIonS
The charger is easy to fix using two screws. Please refer to product drawing.

equIPment

The Carpoint charger is supplied with two detachable and interchangeable colour coded lead
sets- one with clamps for bench charging and other with eyelet terminals (Ø6.3mm) with in-line
battery protection plug-in fuse (2.0A) for permanent attachment to the battery posts to allow
quick connection/disconnection through snap-connector.
14