Carpoint 0635863 Manual De Instrucciones página 6

b) Check polarity of battery post. A positive ("+") battery post usually has a larger diameter
than a negative ("-") post.
c) Identify the pole of battery which is connected to the chassis (earth). Normally the negative
terminal is connected to the chassis.
d) Charging of negative earthed battery:
• Make sure the black wire ("-" pole connection) has not contact with the fuel line or the
battery.
• Connect the red wire ("+") to the positive ("+") pole of the battery and the black wire
("-") to the vehicle chassis.
e) Charging of positive earthed battery:
• Make sure the red wire ("+" pole connection) has no contact with the fuel line or the
battery.
• Connect the black wire ("-") to the negative ("-") pole of the battery and the red wire
("+") to the vehicle chassis.
2) Charging of a battery not connected to a vehicle
a) Before connecting or disconnecting the battery leads, the power cord should be removed
from the mains.
b) Connect the red wire ("+") to the positive ("+") pole of the battery and the black wire
("-") to the negative ("-") pole.
In case of reverse polarity connection red LED
function would not work in Supply Mode. Error indication light
shown if charge mode is initiated without connecting the battery to the battery leads.
3) Charging with eyelet terminals (Permanent connection to the vehicle battery)
a) Before connecting or disconnecting the battery leads, the power cord should be removed
from the mains.
b) Connect the red wire ("+") to the positive ("+") pole of the battery and the black wire
("-") to the negative ("-") pole.
2
indicate error mode. This
2
would be also
5