Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
3. Remove one motor plate screw (E) from posts on
motor plate preassembled on the underside of the
motor housing (D) and partially loosen the other two
motor plate screws (E). Connect male plug from
motor housing (D) to female plug from switch
housing (F), matching up the colors on the plugs for
correct fit. Make sure plugs connect tightly.
Carefully arrange wires inside switch housing (F).
Align slotted holes in switch housing (F) with
loosened motor plate screws (E), allowing male and
female plug connections to come through hole in
switch housing (F). Twist switch housing (F) to lock.
Re-insert the motor plate screw (E) that was
removed and securely tighten all three motor plate
screws (E).
4. Remove one switch housing screw (G) from posts on
the underside of switch housing (F) and partially
loosen the other two switch housing screws (G).
Connect WHITE wire from switch housing to WHITE
wire from light kit fitter (I). Connect BLACK (or BLUE)
wire from switch housing (F) to BLUE wire from light
kit fitter (I). Make sure molex connections are secure.
Align slotted holes in light kit fitter (I) with loosened
switch housing screws (G). Twist light kit fitter (I) to
lock. Re-insert the switch housing screw (G) that was
removed and securely tighten all three switch housing
screws (G).
5.
Install bulb (L).
IMPORTANT: When you need to replace bulb please
allow the bulb (L) and light kit fitter (I) to cool down
before touching.
3
Motor
Plate
I E
4
BLUE
BLACK
G
5
13
Male Plug
Female
Plug
F
I E
WHITE
I
L
D
I E
D
WHITE
G
G
I
Publicidad
