Publicidad
Idiomas disponibles
Idiomas disponibles
8. MAINTENANCE INSTRUCTIONS
8.1 After use and before performing maintenance, unplug and disconnect
the unit.
8.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from
the battery clamps, cords, and the outer case.
8.3 Do not open the unit, as there are no user-serviceable parts.
9. STORAGE INSTRUCTIONS
9.1 Charge battery to full capacity before storage.
9.2 Store this unit at temperatures between - 4°F- + 140°F ( - 20°C- + 60°C).
9.3 Never completely discharge the battery.
9.4 Charge after each use.
9.5 Charge at least once every month, if not in frequent use, to prevent
over-discharge.
10. TROUBLESHOOTING
Jump Starter
PROBLEM
The jump starter turns on, but
won't jump start my vehicle.
The jump starter will not
recharge.
All four LEDs flash.
The last LED flashes, then
turns off.
When cable is correctly
connected to both battery
and jump starter: Green LED
blinking; Red LED off; no beep.
REASON/SOLUTION
Make sure the unit is charged.
Verify the charge level of the jump starter is
at least 50%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualified service technician.
Make sure the power source is live.
Low or high temperature. LEDs will stop
flashing when the condition is corrected.
Over-discharge. Recharge the internal
battery.
"Fake" high battery voltage is detected,
but reverse charging protection did not
activate. User can turn key to jump start
the vehicle.
• 11 •
Publicidad
