Publicidad
EN
DISASSEMBLE INSTRUCTIONS
Be sure to turn off the appliance and disconnect the power supply before
disassembling.
Unscrewthediscnutanti-clockwise.
Press the top cover, lift the end surface of top
cover, and remove it. Take out the mixing axle.
ASSEMBLE INSTRUCTIONS
Be sure to turn off the appliance and disconnect the power supply before
assembling.
Attach the mixing bowl to the appliance, insert the mixing axle into the exposed motor shaft by
pointing to the hexagon hole.
Rotate slightly the mixing axle if needed.
Insert the extruding axle.
Tighten the extruding head to the fastening plate.
Lock the fastening plate clockwise. Insert the disc into the extruding head. Tighten the disc nut
clockwise. Insert top cover into the housing with bayonet pointing to the hole in front of the mixing
bowl. Press it down and finish the assembly with a click sound.
SPECIFICATION
Product Name
Model
Power Consumptioin
Voltage
Dimension
Take out the extruding head and
extrudingaxle.
Unlock the fastening plate anti-clockwise.
Take out the mixing bowl.
Pasta Maker
BGMP-9139
260W
220-240V~50Hz
W186x L307 x H264 (mm)
07
CLEANING & MAINTENANCE
PARTS CLEANING
AIR DRY
Disassemble all the parts, keep aside to be dry in the open air.
MIXING BOWL
MIXING AXLE
Use the cleaning scraper/cloth
Use the cleaning scraper to clean
to clean the mixing bowl after it
the mixing axle after it is dry.
is dry.
ATTENTION: Do not clean all the parts immediately after using, but disassemble all the
parts and let it dry in the open air. Do not immerse the appliance into water/liquid to
prevent electric leakage.
TROUBLESHOOTING
The indicators do not light up
- Check the power outlet and plug is properly connected
- Check the lid is secured and closed properly (safety switch applied)
Display shows
E1
The mixing axle is blocked
E2
The unit is overheated
E3
Malfunction of buttons
EXTRUDING DISC
Use the cleaning scraper
needle to clean the
extruding disc after it is dry.
Check the dough (too dry) or any
obstructions. Clear the objects.
Unplug the unit and restart.
Unplug the unit. Restart after 1 minute.
Check panel and contact customer
service.
08
EN
Publicidad
