Operation; Connecting The Ac Adapter And Ac Power Cord; Connecting Interface Cables - Citizen CBM1000II Serie Manual Del Usuario

3. OPERATION

3.1 Connecting the AC Adapter and AC Power Cord

1 Turn off the power of the printer.
2 For the AC adapter type only: With the flat side of the AC adapter's cable connector
facing upward, insert the cable connector into the power connector on the back side of
the printer.
3 Connect the AC power cord to the inlet of the printer, and insert the AC power-cord
plug into a suitable wall outlet.
Standard type
Inlet
AC adapter type
Inlet
AC adapter cord

3.2 Connecting Interface Cables

1 Turn off the power of the printer. (As well as the connected host computer.)
2 Orient the interface cable terminal correctly and insert it into the interface connector.
3 Secure the cable terminal as shown below.
Serial interface cable: Fasten the connector with screws.
Parallel interface cable: Hold the connector with clamps.
4 Connect the other end of the interface cable to the host computer.
Serial interface cable
AC power cord
Cable connector
AC adapter
Serial interface connector
Power connector
Flat side
Clamps
— 14 —
Power connector pin configuration
No. Function
1 +24
2 GND
3 N.C
SHELL F.G
1
3
2
Connector used:
TCS7960-53-2010 (Hosiden) or
equivalent
Applicable connector:
TCP8927-63-1100 (Hosiden) or
equivalent
TCP8927-53-1100 (Hosiden) or
equivalent
Parallel interface connector
Parallel interface cable