GB
MT
the device by the cutting blade.
Contact with the cutting blade can lead
to injuries.
• Do not use the device near
flammable liquids or gases. In
the event of a short circuit there is a risk
of fire and explosion.
• Always make sure that the device is
properly in one of the specified work-
ing positions before starting the device.
• The blades must be checked
regularly for wear and re-
ground. Blunt blades overload the
device. Any damage that results is not
covered by the warranty.
• Switch off the device and remove the
battery (9). Make sure that all moving
parts have come to a complete stop
• when leaving the device
• before removing obstructions or
loosening blockages
• before checking the device, clean-
ing it or performing maintenance
work on it
• If the cutting unit touches a foreign ob-
ject or the device starts to vibrate ab-
normally, an immediate inspection is re-
quired:
• examine for loose parts and tighten
these
• search for signs of damage
• replace damaged parts with equi-
valent ones or have the device re-
paired.
• Do not try to repair the device
by yourself unless you have
professional training. All work
not mentioned in this instruction
manual may only be performed
by our service centre. Many acci-
dents are caused by poorly maintained
appliances.
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
32
accessories may cause electric shock
or fire.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Eye damage if no suitable eye protec-
tion is worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of hand/arm vibration in the event that
the tool is used over a longer period
of time or is not used and maintained
properly.
• Cutting injuries
WARNING! Danger due to electro-
magnetic field generated while the tool is
in operation. Under certain circumstances,
this field may negatively affect active or
passive medical implants. In order to re-
duce the danger of serious or fatal injur-
ies, we recommend that individuals who
wear medical implants should consult their
doctor and the manufacturer of the im-
plant before operating the machine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Wall bracket
You can hang the motor part on the wall
with the keyhole (16) on the bottom of the
device.
Tools and aids required
• Screw (screw head: ⌀ 8-10 mm)
• Corresponding screwdriver