Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
6
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws.
□
Install the remaining two mounting screws into the holes in
the canopy (C) and tighten firmly.
□
Install the decorative canopy ring (M) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
counter-clockwise to lock in place.
7
Mounting the fan-motor assembly
(close-to-ceiling mount)
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
□
Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately tighten
the two mounting screws firmly.
□
Install the remaining two mounting screws into the holes in
the canopy (C) and tighten firmly.
□
Install the decorative canopy ring (M) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
counter-clockwise to lock in place.
□
You may now proceed to attaching the fan blades.
A
M
C
E
11
Please contact 1-877-527-0313 for further assistance.
A
M
C
E
HAMPTONBAY.COM
Publicidad
