Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Fan Blades
1
Attaching the blade brackets to
the motor
NOTE: Your fan features revolutionary advancements for quick and
easy blade installation.
NOTE: Your fan blades are reversible. Select the blade side finish
which best accentuates your decor.
□
Fasten the blade bracket (H) to the motor (E) by inserting the
alignment post into the slot on the bottom of the fan-motor
assembly (E) and tightening the motor screws.
□
Please note that the motor screws are pre-attached into
the blade bracket (H). Repeat for the remaining four blade
brackets (H).
2
Attaching the blades
□
Mount the fan blades (G) to the blade bracket (H) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (H).
□
Hold the blade (G) with both hands close to the blade bracket
(H) and press the blade (G) down firmly. Ensure the key-slot
holes are properly seated on the blade arm posts.
□
While still holding the blade (G) down with both hands, firmly
slide the blade (G) away from the fan-motor assembly (E) until
the blade (G) engages in the locking mechanism. Make sure
the steel locking mechanism at the rear of the blade bracket
(H) springs upward and butts against the edge of the blade (G)
indicating a secure connection.
□
Visually inspect the top of the blade bracket (H) to ensure the
locking mechanism is securely in place.
□
Repeat for the remaining blades (G).
E
H
12
G
H
Publicidad
