HAMPTON BAY FLOWE 52-SKV Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (M) from the canopy (C) by turning
the ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy by
loosening the four canopy screws (HH) on the top of the
canopy (C).
□
Remove the two non-slotted canopy screws (HH) and loosen
the slotted canopy screws (HH). This will enable you to
remove the mounting bracket (A).
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrew (TT) on the collar
(O) on top of the fan-motor assembly (E).
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (O) on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (BB) through the holes in the
collar (O) and downrod (B). Be careful not to jam the hanger
pin (BB) against the wiring inside the downrod (B).
□
Insert the locking pin (CC) through the hole near the end of
the hanger pin (BB) until it snaps into its locked position.
□
Re-tighten the setscrew (TT) on the collar (O) on top of the
fan-motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan-motor assem-
bly (E) into the decorative motor collar cover (D) and
through the canopy ring (M).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
A
HH
C
M
BB
7
B
Please contact 1-877-527-0313 for further assistance.
C
M
D
B
E
C
D
TT
CC
B
O
E
HAMPTONBAY.COM