Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Your Fan and Remote Control (continued)
3
Setting the code on the remote
control and receiver
NOTE: The frequencies on your receiver and remote
control have been preset at the factory. Before installing
the receiver, make sure the dip switches on the receiver
and remote control are set to the same frequency. The dip
switches on the remote control are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
remote control. Dispose of used battery properly and keep
the battery out of the reach of children.
NOTE: The switch marked ON/DIM controls the dimming
function of the lights: If using CFL bulbs, use a ballpoint pen
or small screwdriver to set the switch to ON to disable the
dimming function. If using standard bulbs, set the switch to
DIM to enable the dimming function.
□
Remove the remote control (J) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the code switches to your choice of either up or down.
The factory setting is up.
□
Slide the code switches on the receiver (K) to the same
position as set on the remote control (J).
□
Replace the battery cover on the remote control (J).
ON
DIP
ON
DIM
1
2
3
4
12V 23A
ON
DIP
ON
DIM
3
1
2
4
J
ON
DIP
1
2
3
4
K
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
CAUTION: Do not install in a damp location or immerse
in water (For indoor use only). Do not pull on or cut leads
shorter. Do not drop or bump the unit.
□
Position the supply wires to the left side of the slide-on
mounting bracket (A); position the fan wires to the right
side. Partially insert the receiver (K) (flat side up) until one
end rests on the ball/downrod assembly (B).
9
Please contact 1-877-527-0313 for further assistance.
K
A
C
B
HAMPTONBAY.COM
Publicidad
