RIDGID HD1612M0 Manual Del Usuario página 18

ASSEMBLY
WET/DRY VAC ASSEMBLY:
POWERHEAD ASSEMBLY (Fig. 3)
1. To Attach the Powerhead Assembly to Dust Drum:
Place Powerhead Assembly (A) on top of Dust
Drum (B) with the Extended Lip of the Lid aligned
with the Drum Vac Inlet. Be sure Powerhead
Assembly is fully seated on the Dust Drum.
2. Press in on the Two Latches, located on either side
of the Dust Drum (B) until they snap into place,
securing the Powerhead Assembly (A) to the Dust
Drum (B).
3. To Remove the Powerhead Assembly: Pull out on
the Two Latches and lift Powerhead Assembly (A)
from the Dust Drum (B). Do not force the Latches
to rotate more than slightly outside Drum flange.
(A)
(B)
SP7115-1 HD1612M0 SE.indd 18 SP7115-1 HD1612M0 SE.indd 18
CARRY HANDLE/CORD WRAP ASSEMBLY (Fig. 4)
1. Locate the Carry Handle/Cord Wrap (D) and the Two
#10 x 19mm (3/4") Pan Head Screws (E) in loose
parts bag.
2. Position the Carry Handle/Cord Wrap (D) on top
of the Powerhead Assembly (A), with the Carry
Handle/Cord Wrap Extended Flange to the rear of
the Powerhead Assembly, as shown.
3. Insert a #10 x 19mm (3/4") Pan Head Screw
through the Hole at each end of the Carry Handle/
Cord Wrap and into the Powerhead Assembly.
Tighten securely.
(D)
Fig. 3
(A)
Latches
Drum
Vac
Inlet
HOSE STORAGE CLIP ASSEMBLY (Fig. 5)
1. Locate the Two Hose Storage Clips (F) and Four
#10 x 3/4" (19 mm) Pan Head Screws (E) in the
loose parts.
2. Place a Hose Storage Clip (F) into the Powerhead
Assembly recess next to one of the Latches.
The Curve of the Clip should face outward.
3. Insert a #10 x 19mm (3/4") Pan Head Screw into
each mounting hole and tighten securely. Repeat
on the other side.
(E)
(F)
(A)
Latches
18
(E)
Fig. 4
Fig. 5
7/30/20 8:42 AM 7/30/20 8:42 AM