Robot Welding Cell En - Abicor Binzel Maxi Flex/HD Instructivo De Servicio

MasterLiner Maxi Flex/HD; Basic Flex/HD
6.2 Laying
6.2.1 Robot welding cell
CAUTION
Device damage
Device damage as a result of inadequate strain relief on the wire feeder.
• Ensure sufficient strain relief on the wire feeder.
• Connect and lay the MasterLiner without kinks.
CAUTION
Device damage
Device damage as a result of unsuitable suspension devices.
• Only use suitable suspension devices when suspending the MasterLiner.
• Do not suspend the MasterLiner using cable ties.
CAUTION
Wire feed irregularities
Wire feed irregularities due to the lowest permissible bending radii being breached, too many bending radii and wire
feed distances exceeding 25 m.
• Please note the specifications with regard to the permissible bending angles, bending radii and maximum lengths.
 3.2 Suspension/total bending angle of all bending radii on page EN-7
• Use an additional drive in the event of wire feed distances of over 25 m.
1 Welding robot
2 Robot welding cell
Fig. 9 Robot welding cell setup
1 Wire feeder
Fig. 10 Robot welding cell installation
BAL.0510.0 • 2018-08-16
1
6
5
4
3
3 Wire drum 5 Lead-through from MasterLiner protective
4 MasterLiner housing to robot welding system
1
2
2 Robot welding system
6 Commissioning
6 Wire feeder
2
EN - 13