Risk Of Burns; Welding Process - Abicor Binzel ABIROB W Serie Traducción Del Manual De Instrucciones Original

®
ABIROB W
7 Operation

7.1 Welding process

DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
During the welding of work-pieces that have been degreased with chlorine-
containing solvents phosgene gas is formed.
• Do not inhale fumes and vapors.
• Ensure a sufficient supply of fresh air.
• Rinse the workpieces with clean water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
DANGER

Risk of burns

During welding work spraying sparks, glowing work-pieces or hot slag can
produce flames.
• Check the work area for flashpoints.
• Provide appropriate fire extinguishing equipment in the workplace.
• Allow workpieces to cool down after welding.
• Prior to performing welding work, properly fasten the ground clamp to
the workpiece or welding table.
WARNING
Arc burn of the eyes
The arc produced by welding can damage the eyes.
• Check and wear your personal protective equipment.
NOTICE
• Never pull the cable assembly across sharp edges or place it in the
welding spatter area or on hot workpieces.
• Ensure that all required parameters, for example welding current, wire
feed, etc., have been set at the welding power supply according to your
welding task.
1 Open the shielding gas cylinder.
2 Switch on the power supply.
7 Operation
EN - 15