Publicidad
Step 2
å
Fasten the RAILS (K, J and Q) to the LEFT FRONT/
RIGHT REAR POST (B) and REAR POST (C). Turn
sixteen 5/8" HEX HEAD SCREWS (6) through
sixteen SPRING WASHERS (1), through sixteen FLAT
WASHERS (2), through the RAILS and into the POSTS
a few turns using the L-WRENCH (3).
å
NOTE: Do not completely tighten the SCREWS at
this time.
5/8" HEX HEAD SCREW
(16 used in this step)
3
(16 of each used)
Page 6
6
Edge without
brackets
2
1
6
www.sauder.com/service
K
J
C
J
The label on the HEAD END
RAIL (Q) should be here.
Q
Edge without
brackets
B
430362
Publicidad
