Parkside PABH 20-Li B2 Traduccion Del Manual De Instrucciones Originale página 49

Fuse (internal):
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Protection class:
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically:
Hammer drilling:
Sound pressure level: L
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hearing protection!
Total vibration value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Hammer drilling in concrete: a
K = 1.5 m/s 2
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the electric tool
in such a way may cause the user to underes-
timate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. All states of
operation must be taken into account (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
PABH 20-Li B2
T3.15A
3.15 A
21.5 V (DC)
2.4 A
approx. 60 min
II / (double insulation)
= 86.5 dB(A)
pA
3 dB(A)
L = 97.5 dB(A)
WA
3 dB(A)
= 4.724 m/s
h(HD)
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance
with the standardised measuring procedure
specified in EN 60745 and can be used to
make equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
2 ,
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1. Work area safety
a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ MT │
45 ■