Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING AND STOPPING PROCEDURE
BEFORE STARTING THE ENGINE:
Fill the fuel tank as instructed in the BEFORE OPERATION section of this manual. Rest the Hedge
Trimmer on the ground. Make sure that the cutting blades are clear of branches, shrubs, debris, etc. Keep
all bystanders, children, and animals away from the working area.
STARTING THE ENGINE (for the carburetor with primer bulb)
The carburetor on this engines contain a choke system and are designed to start at IDLE speed.
1. Push and release the fuel primer bulb located on the bottom
of the carburetor until air bubble free fuel is seen flowing
through the clear fuel return hose back to the fuel tank.
2. Move the choke lever to the closed position "
engine is warm, move the choke lever to the open position
"
".
3. Set the engine stop switch to the "ON ( | )" position. The
throttle trigger positioned at IDLE.
4. Grasp the starter grip, slowly pull the starter cord out until
you feel some resistance, then pull the cord quickly and
powerfully. Pull the starter grip until the engine starts. After
the engine is started, move the choke lever to the open
position.
5. After starting, allow the engine to run a few minutes to warm
it up before using.
Before starting the engine, place the machine on the ground and make sure the blade is free from
branches and stones.
". When the
─ 13 ─
PRIMER BULB
PUMP
FUEL-RETURN LINE
STOP (O) ←→ ON ( | )
STOP SWITCH
English
Publicidad
