Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
1.
Do not pull the starter cord out completely.
2.
Do not release the starter cord from the fully extended position.
To Stop The Engine:
1.
Release the throttle trigger.
2.
Slide the stop switch to the "STOP" position.
This Hedge Trimmer is equipped with non-adjustable fuel mixture carburetor. The engine idle speed is the
only adjustment to the Operator.
The cutting blades may be moving during idle speed adjustment. Wear the recommended personal
protective equipment and observe all safety instructions. Keep hands and body away from blade area.
Engine Idle Speed:
When the throttle trigger is released the engine should return to an idle speed which is 2700-3300 rpm or
just below clutch engagement speed. The cutting blades must not move and the engine should not stall
(stop running) at engine idle speed.
The engine idle speed is adjusted by rotating the idle
speed screw on the carburetor. Turning the idle speed
screw, clockwise increases engine speed while turning the
screw counterclockwise decreases engine speed.
If idle speed adjustment is necessary, after adjustment, if the cutting blades move or the engine
stalls, stop using the Hedge Trimmer immediately!
Contact your local authorized BAD BOY Dealer for assistance and servicing.
English
CARBURETOR ADJUSTMENT
IDLE SPEED
ADJUSTMENT
SCREW
─ 14 ─
Publicidad
