Publicidad
Idiomas disponibles
Idiomas disponibles
FIG.3
3 mm ALLEN WRENCH
SUPPLIED IN TOOL KIT
SPARK ARRESTER
Maintenance Interval: The spark arrester should be
inspected and cleaned after every 25 hours of use.
Replace the screen if it cannot be thoroughly cleaned
or if it is damage.
Maintenance: With the engine at ambient (room)
temperature. Remove the two socket head screws
holding the tail and spark arrester to the muffler.
Remove and clean the tail, gasket, and spark arrester
with a safety solvent and a stiff brush. If any part
cannot be thoroughly cleaned it must be replaced.
Reinstall the spark arrester and tail onto the muffler,
then reinstall and tighten the two socket head screws.
EXHAUST MUFFLER
Maintenance Interval: The muffler should be inspected and cleaned after each 100 hours of use.
Maintenance: Remove the engine cover (See Cylinder Cooling Fins). Remove the spark arrester (See
Spark Arrester maintenance), and clean the muffler with a stiff brush. Reinstall the spark arrester and onto
muffler, then reinstall and tighten the two socket head screws. Reinstall the cylinder cover then tighten the
knob. Reinstall the tail pipe and cover.
IMPORTANT: Do not use solvent for cleaning inside of muffler due to the catalytic converter in
muffler. Be careful not to allow any dirt or debris to fall into the exhaust port, as this can cause
engine damage.
English
KNOB
CYLINDER COVER
SOCKET
HEAD SCREW
─ 18 ─
SPARK ARRESTER
TAIL
Publicidad
