Publicidad
Idiomas disponibles
Idiomas disponibles
Grounding
Ensure proper
ground
and firm
connection
before use.
•
The plug must be firmly plugged into a three-prong outlet that is properly
installed and grounded in accordance with all local codes and ordinances. In
the event of a malfunction or breakdown, grounding will decrease the risk of
electrical shock by providing a path for the electric current.
•
Do not use a damaged power plug or loose wall outlet.
•
Do not use an extension cord or adapter with this appliance.
•
Do not, under any circumstances, cut, modify, remove, or otherwise defeat the
grounding (third) prong from the power cord. If the plug and the outlet do not
match or you have any doubt, have a qualified electrician install the proper
outlet.
The customer should have the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle is properly grounded.
Ground Fault Circuit Interrupters(GFCIs) are not required or recommended for
gas range receptacles.
•
NEVER connect ground wire to plastic plumbing lines, gas lines, or water
pipes.
CAUTION
Failure to follow these instructions can result in death, fire, or electrical shock.
Install_DOP36T86GLS_DG68-01106F-00_EN+MES+CFR.indb 17
Install_DOP36T86GLS_DG68-01106F-00_EN+MES+CFR.indb 17
•
All ranges must be grounded for
personal safety.
•
All gas models have a power cord with
an equipment-grounding conductor and
a grounding plug.
Usage situations where appliance power cord will be disconnected frequently
Do not use an adapter plug in these situations because disconnecting of the power
cord places under strain on the adapter and leads to eventual failure of the adapter
ground terminal. Where a standard two-prong wall receptacle is encountered, it is
the personal responsibility and obligation of the customer to have it replaced with
a three-prong (grounding) receptacle by a qualified electrician before using the
appliance.
Additional installation requirements for mobile homes
The installation of appliances designed for mobile home installation must conform
with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home Construction and Safety,
Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard
for Manufactured Home Installations, latest edition (Manufactured Home Sites,
Communities and Set-Ups), ANSI A225.1, latest edition, or with local codes. In
Canada, mobile home installation must be in accordance with the current CAN/CSA
Z240/MH Mobile Home Installation Code.
Power cord location
The power cord for this appliance is located
on the back of the range, near the bottom
left corner. The 53 in (135 cm) power cord
will come installed on the range and taped
to the back for shipping.
Power cord
English 17
2023-02-28 오전 10:32:42
2023-02-28 오전 10:32:42
Publicidad
