Descargar Imprimir esta página

Medion MD 37689 Guida Rapida página 99

Ocultar thumbs Ver también para MD 37689:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58
 Ensure that no part of the refrigerant circuit is damaged when
transporting and installing the appliance.
 Where possible, always transport the appliance upright. If
tilted to an angle of more than 40° during transport, wait
4 hours before connecting it to the mains and switching it
on to enable the refrigerant circuit to return to normal after
transport.
 Do not place the appliance on its side or back, as this can
cause oil from the compressor to enter and block the
refrigerant circuit.
 Do not expose the appliance to rain or spray water.
.. Installation and electrical connection
...
Location
NOTICE!
Possible material damage!
Risk of damage to the appliance due to improper
handling
 Install the refrigerating appliance in a dry and ventilated
room. The room should be approx. 4 m² to ensure that
sufficient air volume is available if the refrigeration system
becomes damaged.
 Take the space requirements into consideration when setting up
the appliance (see '7.1. Setting up the appliance' on page 106).
 The appliance is suitable for climate class N (see the type plate).
The cooling performance of the appliance is guaranteed at
ambient temperatures from 16°C to 32°C. If temperatures deviate
from this range, the appliance performance may be reduced.
 Do not use the appliance outdoors.
 Do not expose the device to extreme conditions. Avoid:
high humidity or wet conditions
extremely high or low temperatures
direct sunlight
open flames.
100

Publicidad

loading