Descargar Imprimir esta página

Black and Decker NHT518 Manual De Instrucciones página 4

Ocultar thumbs Ver también para NHT518:

Publicidad

Idiomas disponibles

Idiomas disponibles

_SAFETY WARNINGS AND
INSTRUCTIONS
CHARGING
1. This manual contains
important safety and operating
instructions.
2.
Before
using battery
charger,
read all instructions and cautionary
markings
on (1) battery
charger,
(2) battery
pack, and (3)
product
using battery
pack.
3.
,'_\ CAUTIONs
To reduce the risk of injury, charge
only
Black
& Decker
Battery
Packs. Other types
of batteries
may
burst causing
personal
injury and damage.
4.
Do not expose charger
to rain or snow.
5.
Use of an attachment
not recommended
or sold by Black
&
Decker
may result in a risk of fire, electric
shock,
or injury to
persons.
6.
To reduce
risk of damage
to electric
plug and cord, pull by plug
rather
than cord when
disconnecting
charger.
7.
Make
sure cord is located
so that it will not be stepped
on,
tripped
over, or otherwise
subjected
to damage
or stress.
8.
An extension
cord should
not be used unless
absolutely
necessary.
Use of improper extension
cord could
result in a risk
of fire, electric
shock
or electrocution.
a. Two-wire
cords can be used with 2-wire or 3-wire extension
cords. Only round jacketed
extension
cords should
be used, and
we recommend
that they be listed by Underwriters
Laboratories
(U.L.).
If the extension
is to be used outside,
the cord
must be
suitable
for outdoor
use. Any cord marked
for outdoor
use can
also be used for indoor work. The letters
"W" or "WA" on the
cord jacket
indicate that the cord is suitable
for outdoor
use.
b. An extension
cord must have
adequate
wire size (AWG or
American
Wire Gauge)
for safety,
and to prevent
loss of power
and overheating.
The smaller
the gauge
number
of the wire, the
greater
the capacity
of the cable;
that is, 16 gauge has more
capacity
than 18 gauge. When
using
more than one extension
to
make up the total length, be sure each
extension
contains
at
least the minimum
wire size.
CHART
FOR MINIMUM
WIRE SIZE (AWG) OF EXTENSION
CORDS
NAMEPLATE
RATING
AMPS
- O - 1O.O
Total Extension
Cord
Length
(ft)
0-25
26-50
51-100
101-150
(0-7,6m)
(7,6-15,2m)
(15,2-30,4m)
(30,4-45,7m)
Wire Gau qe
18
16
16
14
9.
Use only the supplied
charger
when
charging
your unit. The use
of any other charger
could damage
the battery pack or create
a
hazardous
condition.
10. Use only one charger
when charging.
11. DO not attempt
to open the charger
or the unit. There
are no
customer
serviceable
parts inside.
Return
to any authorized
Black & Decker
service
center.
12. DO NOT incinerate
battery
packs even
if they are severely
damaged
or completely
worn out.
13. Do not incinerate
the batteries.
They can explode
in a fire. A
small leakage
of liquid from the battery cells may occur
under
extreme
usage,
charging
or temperature
conditions.
This does
not indicate
a failure. However,
if the outer seal is broken
and
this leakage
gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize
with a mild acid such as lemon juice or vinegar.
c. If the battery
liquid gets in your eyes, flush
them with clean
water
for a minimum
of 10 minutes
and seek immediate
medical
attention.
MEDICAL
NOTE: The liquid is a 25-35%
solution
of
potassium
hydroxide.
£WAR """--NING"
N .....
ttempt to open the battery pack
for any reason.
If battery
pack case is cracked or damaged,
do not
insert into charger.
Do not crush, drop or damage
battery pack.
Do
not use a battery pack or charger
that has received
a sharp blow,
been dropped,
run over or damaged
in any way (Le., pierced with a
nail, hit with a hammer,
stepped
on). Damaged
battery packs
should
be returned
to service
center for recycling.
Z_ CAUTION:
When not in use, place tool on its side on a stable
surface
where
it will not cause a tripping
or falling hazard.
Some
tools with large battery packs will stand
upright
but may be easily
knocked
over.
Battery
Cap
Information
A battery
storage
and carrying
cap is provided
for use whenever
the
battery
is out of the tool or charger.
Remove
cap before
placing
battery
in charger
or tool.
Battery
Cap
±WARNI NG:
Fire hazard.
Do not st .......
ry
battery
so that metal
objects
can contact
exposed
battery
terminals.
For example,
do not place battery
in aprons,
pockets, tool
boxes,
product
kit boxes,
drawers,
etc., with loose
nails, screws,
keys, etc. Transporting
batteries
can possibly
cause fires
if the
battery
terminals
inadvertently
come in contact
with conductive
IMPORTANTCHARGINGSAFETY
INSTRUCTIONS
CHARGING
PROCEDURE
THE BATTERY
PACK IS NOT FULLY CHARGED
AT THE
FACTORY.
CHARGE
BATTERY
PACK FOR AT LEAST 9 HOURS
BEFORE
USE.
The charger
is designed
to use standard
household
120 volt 60 Hz
power.
1. Plug the charger
into any standard
120 Volt
60 Hz electrical
outlet
(figure
1).
2. Slide the charger
onto the battery pack as
shown
in figure
2 and let the battery
pack
charge
initially for 9 hours.
After the initial
charge,
under
normal
usage, your battery
pack should
be fully charged
in 6 to 9 hours.
2a) During
charging
the green LED will appear.
2b) When
charging
is complete
the green LED
will go off.
3. Unplug
charger,
and remove the battery pack,
Place the battery
pack into the tool until it
_)
"clicks"
into place.
NOTE:
TO remove
the battery
pack,
press
down on the release
button on the back of the
battery
pack and slide out (figure
3).
materials
such as keys,
coins, hand tools
and the like. The US
Depadment
of Transportation
Hazardous
Material
Regulations
(HMR)
IMPORTANT
CHARGING
NOTES
1. After normal
usage, your
battery
pack should
be fully charged
in
actually
prohibit transporting
batteries
in commerce
or on airplanes
(i.e., packed
in suitcases
and carry-on
luggage)
UNLESS they are
6 to 9 hours.
If the battery
pack is run-down
completely,
it may
properly
protected
from short circuits.
So when
transporting
individual
take up to 9 hours
to become
fully charged.
Your battery
pack
batteries,
make
sure that the battery
terminals
are protected
and well
was sent from the factory
in an uncharged
condition.
Before
insulated
from materials
that could contact them and cause
a short
attempting
to use it, it must be charged
for at least 9 hours.
circuit.
2. DO NOT charge
the battery pack in an air temperature
below
7

Publicidad

loading

Este manual también es adecuado para:

Nht524