Publicidad
Idiomas disponibles
Idiomas disponibles
Battery
The battery is located under the
driver's seat cushion. The battery
equipped for this vehicle is a
valve-regulated
wet-load
battery. It is strictly prohibited to pry
open the shell. There is no need for
fluid replacement before and during
use.
Read and observe the following precautions before
use:
1. Check the battery terminal voltage when it is
used for the first time. When the voltage is less
than the 12.6 V, it is necessary to charge: charge
voltage 14.4 ± 0.02 V, charge limit current 11.2 a,
charge until the current drops to 0.2 a (or refer to
the relevant parameters printed on the surface of
the battery). If the temperature of the battery is
higher than 45℃ during charging, stop charging
immediately and charge again after the tempera-
ture drops.
2.The battery terminal red is positive and black is
negative. Turn off the power supply during
free
45
wiring, connect the positive electrode first and
then the negative electrode; remove the negative
electrode first and then the positive electrode
during disassembly.
3.Charging system test: After the vehicle is start-
ed, the battery voltage displays between 13.5 V
and 15 V, indicating that the charging system is
normal.
4. Vehicle leakage current detection: turn off the
power supply of the vehicle, connect the positive
or negative pole in series with the multimeter
(current gear), the current is less than 3mA, and
the vehicle circuit is normal.
5. When the motorcycle is not used for a long
time, it should be recharged once a month, or the
battery should be removed and placed separate-
ly, and the voltage should be detected once
every three months. When the voltage is lower
than the 12.6 V, it should be recharged. It is not
allowed to store the battery in the state of lack of
electricity.
Publicidad
