Dreame H14 Manual Del Usuario página 7

Charging
EN
1. Place the charging base against a wall on level ground and connect it to a
power source. Fully charge the appliance before first use.
2. Place the appliance on the charging base. When the number on the display screen
reaches 100, the battery is fully charged.
Charging/Low Battery Indicator
Orange Breathing: Battery level ≤ 20% (charging)
•
Green Breathing: Battery level > 20% (charging)
•
Solid Green: Full charged
•
• Solid Orange: Battery level≤20%
Note:
• If there is no operation within 10 minutes of being fully charged, the vacuum will enter sleep mode. Please
restart the appliance if you need to use it.
• To extend the battery life time, the battery keeps cooling down automatically after you have used the
appliance for a long time.
8
How to Use
Filling the Clean Water Tank
1. Press the Clean Water Tank release button
to remove the tank. Open the tank cover and
fill the tank with clean water.
Adding Cleaning Fluid
1. Remove the seal before use.
2. Measure the floor cleaner with the bottle cap (*approximately 1.5 ml/0.05 fl oz per
cap).
3. Pour it into the Clean Water Tank at a dilution ratio of 1:200, and gently shake to mix
evenly before use.
Note:
• For deep cleaning, a dilution ratio of 1:30 is recommended.
• Do not add any liquids other than the officially-approved cleaner. The cleaner can be available on the official online
store
WARNING: To reduce the risk of fire and electric shock due to internal component damage, use only dreame HFF3
cleaning fluid intended for use with the appliance.
Starting Cleaning
Gently step on the brush cover
and recline the appliance
backwards. Press the power
switch to start/stop operating.
If the appliance is in the upright
position while working, the
current task will be suspended.
The appliance is designed for
lying flat at a 180-degree angle,
enabling it to reach and clean
under the low-profile furniture.
Note:
• Do not vacuum any foamy liquids.
• Make sure the appliance is in upright position before turning off the power while the appliance is lying flat.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• When the appliance is in operation, do not lift it off the ground, move it or tilt it. Otherwise, the used water may flow
into the motor.
2. Install the Clean Water Tank and ensure it
clicks into place.
EN
9