Publicidad
Step 19
1
D30
Groove
å
Insert the DRAWER SIDES (D30 and D31) at an angle
into the slot at each end of the DRAWER FRONT (L).
3
Minimum
190 degrees
M67
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M67) to the DRAWER
FRONT (L). Tighten one HIDDEN CAM.
Page 24
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
L
D31
Maximum
Arrow
210 degrees
Hidden part using
recycled material.
Color may vary.
L
VIEW THE T-LOCK BOX VIDEO
2
U n fi
n i s h
s u r
f a c
D30
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D988) into the grooves
in the DRAWER SIDES (D30 and D31) and
DRAWER FRONT (L).
4
D30
M67
å
Fasten the DRAWER BACK (D183) to the DRAWER
SIDES (D30 and D31) and DRAWER BRACE (M67). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S). Repeat
this step for the other DRAWERS.
425011
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
e
D988
L
D31
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(5 used in this step)
D183
D31
www.sauder.com/service
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Publicidad
