Publicidad
Step 4
Place the WASHER (82S) into one of the MOLDING CONNECTOR CLIPS (173M) as shown in the enlarged
å
diagram. Using your hammer, gently tap on the WASHER to insert the MOLDING CONNECTOR CLIP into the
hole in the RIGHT END (A).
Repeat this method to insert all of the MOLDING CONNECTOR CLIPS (173M) into the ENDS (A and B).
å
Line up the grooves in the END MOLDINGS (E) over the MOLDING CONNECTOR CLIPS in the ENDS (A and B)
å
and snap the MOLDINGS onto the CLIPS.
NOTE: The MOLDINGS should be centered on the ENDS.
å
www.sauder.com/service
A
B
A
B
E
425011
Use your hammer to tap the WASHER (82S)
into the MOLDING CONNECTOR CLIP (173M).
Be sure the MOLDING
CONNECTOR CLIP is
parallel to the short edge.
(6 used)
173M
E
82S
173M
Page 9
Publicidad
