CBT200
27-05-2002
11:24
D E S C R I P T I O N O F A P P L I A N C E
A) ON lever
B) Browning control dial
C) Defrost button + light
D) Reheat button + light
E) Stop/clear button
F) Crumb collection tray
G) Bread toasting slots
H) Removable "Warming Rack"(only for some
models)
USE OF THE COMMANDS
• Make sure that the lever (A) is raised and the
dial (B) is set for a medium toasting level.
• Connect the appliance to the electrical outlet.
In order to eliminate the "new" smell at the
first use, operate the appliance without any
food inside for at least 5 minutes. Aerate
the room during this operation.
• Insert the slices of bread into the bread toa-
sting slots (G) and lower the lever (A) until it
is all the way down.
Note: If the appliance is not connected to the
electrical outlet, the lever will not go all the
way down.
• When the toasting is finished, the lever
returns to the up position, raising the toasted
bread slices at the same time.
• If the bread is not sufficiently toasted, select a
darker degree of toasting by turning the dial (B).
If it is too dark, select a lesser degree of toasting.
• The toasting can be interrupted at any time by
simply pressing the stop/clear button (E).
Defrost function
You may toast slices of frozen bread by pressing
the defrost button (C) immediately after having
lowered the lever (A); the cooking cycle will be
lengthened in order to achieve the desired toa-
sting level. The warning light will remain lighted
while the defrost function is in use.
Reheat function
Press down control lever (A) and press the reheat
button (D). The reheat light will remain on whilst
the reheat function is in use. Please note that this
is a fixed reheat time which cannot be adjusted
by the browning control.
Pagina 5
"WARMING RACK" device (H)
Use this device to heat croissants.
• Fasten the grill to the appliance by first inser-
• Rest the croissant on the grill.
• Turn the browning control dial (B) to the
• Press down the control lever (A) until it clicks
• If the croissant is not warm enough, next time
SUGGESTIONS
• Never use the appliance when it is empty
• Do not use very thin or broken slices of bread.
• Do not insert other foods that may drip
• Do not insert (by force) foods that are too big
• Do not insert forks or other utensils into the
CLEANING AND MAINTENANCE
• Any cleaning and/or maintenance operation
• Let the appliance cool down before procee-
• The external part of the appliance must be
• DO NOT IMMERSE IN WATER.
• After each use, remove the plug from the elec-
• If a toast slice should become lodged in the
• NEVER TOUCH ANY PART OF THE TOASTER
ting the hooks 1 and then clicking in the
hooks 2, as shown in the Figure on page 3.
desired position.
into place.
select a darker level of toasting.
(when there is no bread inserted).
during the cooking process. In addition to
making the cleaning procedure more difficult,
these may cause fires. It is also very impor-
tant to clean the crumb collection tray of any
drippings before each use.
for the slots.
toaster in order to remove bread, in so far
as it may damage the resistance coils of the
appliance. Remove the plug from the outlet
and turn the appliance over, gently shaking it
to remove the lodged item.
must be done after having removed the plug
from the electrical outlet.
ding with its cleaning.
cleaned with soft cloth. Do not use abrasive
detergents which could ruin the surface.
trical outlet and empty the crumb collection tray
which is situated under the appliance.
toaster, unplug the appliance, turn it upside
down, and shake the toaster gently.
WITH SHARP UTENSILS, ESPECIALLY INSIDE
THE BREAD TOASTING SLOTS.
5