Shark HYDROVAC WD200EU Serie Manual De Instrucciones página 21

USING YOUR 2-IN-1 CLEANER
POWER
Press and release the Power button on the handle
to turn on power. To turn off power, press the
button again.
CLEANING MODES
HARD FLOOR MODE
Use Hard Floor mode for powerful cleaning on bare
floors. To activate Hard Floor mode, turn on the unit
and tilt the handle back.
NOTE: To prevent leakage, DO NOT place the main body on the floor. The nozzle should always be kept flat on the floor.
s h a r kc l e a n . e u
CONTROLS
AREA RUG MODE
To clean area rugs, press the Area Rug icon on top
of the handle. The Area Rug light on the main body
will illuminate. To turn off Area Rug mode, press the
button again.
MAINTAINING YOUR 2-IN-1 CLEANER
SELF-CLEANING MODE
1.
Place the unit on the Storage and Charging Dock.
The Self-Clean mode icon located on the top of
the main body will pulse.
2. Empty the Dirty Water Tank and make sure the
clean solution tank is at least half full.
3. Press the Power Button to start the self-clean
cycle. The icon will illuminate for the full 2-minute
duration of the cycle.
4. DO NOT remove the unit from the dock during
the self-cleaning cycle. The icon will turn off when
the cycle is complete.
5. Empty the dirty water tank.
NOTE: Make sure the clean solution tank is at least half full and that the dirty water tank is empty before running the self-
cleaning cycle.
s h a r kc l e a n . e u