voestalpine bohler URANOS 3200 PME Instrucciones De Uso página 29

4 ACCESSORIES
4.1 General
Operation of the remote control is activated when connected
to the power sources. This connection can be made also with
the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.
4.2 RC 100 remote control
The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".
4.3 RC 180 remote control
This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".
4.4 RC 200 remote control
The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
"Consult the instruction manual".
4.5 SR 17/26V series torches
4.6 MIG/MAG series torches
"Consult the instruction manual".
4.7 DIGIMIG - MIG/MAG series torches
The MB501D PLUS series torches are digital MIG/MAG torches
allowing the main welding parameters to be controlled:
- welding current (Synergic MIG/MAG process)
- arc length (Synergic MIG/MAG process)
- wire speed (Manual MIG/MAG process)
- welding voltage (Manual MIG/MAG process)
- program recall
and the real values to be displayed for:
- welding current
- welding voltage
29