Publicidad
Idiomas disponibles
Idiomas disponibles
CHAPTER -5: TROUBLESHOOTING
Your Fridge Freezer is equipped with a built in fault detection system, which is able to give you guidance should your
fridge freezer not operate as expected. In the event of an error a symbol will be displayed on the control panel. The
most common error symbols are shown below. If your fridge freezer displays a symbol not shown below contact the
Sharp help-desk.
ERROR DISPLAY
and audible warning
or
Troubleshooting information
If you are experiencing a problem with your refrigerator, please check the following before contacting the after-sales
service.
If your fridge is not operating;
• Is there a power failure?
• Is the plug connected to the socket correctly?
• Is the fuse of the socket to which the plug is connected or the main fuse blown?
• Is there any failure at the socket? To check this, plug your refrigerator into a known working socket.
If your fridge is not cooling enough;
• Is the temperature adjustment right?
• Is the door of your fridge opened frequently and left open for a long while?
• Is the door of fridge closed properly?
• Did you put a dish or food on your fridge so that it contacts the rear wall of your fridge so as to prevent the air
circulation?
• Is your fridge filled excessively?
• Is there adequate distance between your fridge and the rear and side walls?
• Is the ambient temperature within the range of values specified in the operating manual?
If the food in your refrigerator compartment is over cooled
• Is the temperature adjustment right?
• Are there many food recently put inside the freezer compartment? If so, your fridge may over cool the food
inside the refrigerator compartment as it will operate longer to cool these food.
If your fridge is operating too loudly;
To maintain the set cooling level, compressor may be activated from time to time. Noises from your fridge at this time
are normal and due to its function. When the required cooling level is reached, noises will be decreased automatically.
ERROR TYPE
Part of your Fridge
Freezer may not be
Error warning
working properly,
or there could be a
cooling problem.
This could be the
Freezer
result of a power
compartment is not
supply disruption or
cold enough.
failure of the cooling
equipment.
This could be the
result of a power
Fridge compartment
supply disruption or
is not cold enough
failure of the cooling
equipment.
The refrigerator
Food in the
compartment is too
refrigerator is at risk
cool.
of being frozen.
This symbol is
intended for advice
The supply voltage
and to act as a
has dropped below
precaution. It will
170V.
disappear once the
supply voltage rises
above 170V.
REMARK
Contact the Sharp Help-desk
Use the SUPERFREEZE mode, or set
the freezer compartment to a lower
temperature until the warning symbol
disappears. Do not place fresh food in the
freezer compartment when this warning
symbol is showing.
Use the SUPERCOOL mode or set the
refrigerator to a lower temperature until
the warning symbol disappears. Do not
open the door while the warning system is
displayed.
Cancel the SUPERCOOL function if it is
active. Decrease the temperature of the
fridge compartment.
EN -12-
DO's
-
Publicidad
