The Reach Will Be Improved When Seeking The Tension - Amprobe AT-2032 Manual De Instrucciones

The reach will be improved when seeking the tension

Example 1 (dual-pole application)
The reach will be improved when seeking the tension:
If the transmitter is attached at the
phase and the neutral coil directly gets
lost the signal in the line going
parallelly to and back (see figure).
The signal raise each other. The reach
is therefore only approx. 5 cm
To turn the effect pointed in the upper
figure off, the connection schould be
carried out like the lower figure. The
backline is produced about a seperate
cable. The distance in in voltage-
circuits will be up to 40 cm. Back coils
at higher distance i.e. Cabletrace
Respect safety instructions when
connecting under voltage.
15