Tracing Installed Water And Heating Pipes - Amprobe AT-2032 Manual De Instrucciones

Tracing installed water and heating pipes.

Example 11 (single-pole application)
ATTENTION ! For safety reasons the electrical system must not be live !
NOTE:
By touching the contact electrode „7" the sensitivity range is increased to factor 1.5.
The following has to be respected:
The line to be located must be separated from the equipotential bonding.
Connect transmitter at foundation ground to the ground socket. The second transmitter
socket has to be connected to the conductor to be located.
Now the feed line can be traced.
26