TROU BLESHOOTI NG
PROBLEM
Barbecue not heating
Circuit breaker trips or fuse blows
Barbecue will not cook properly
Flare-ups
Controller indicator light is not lit.
Persistent grease fire
POSSIBLE CAUSE
•
Controller turned to OFF position.
•
No power.
•
Faulty controller or heating element.
•
Power surge.
•
Another appliance plugged into same circuit as barbecue.
•
Moisture or water in controller or electrical connections.
•
Damaged cord or electrical connections.
•
Lid of barbecue is left open.
•
Insufficient preheat or temperature set too low.
•
Inappropriate extension cord.
•
Excessive buildup on porcelain bowl.
•
Excess fat in meat.
•
Excessive cooking temperature.
•
Grease build up.
•
Normal controller cycling.
•
No power.
•
Faulty controller.
•
Grease trapped by food build up.
SAVE THESE INSTRUCTIONS
Pa ge 6
PREVENTION / SOLUTION
•
5
HIGH.
Turn controller knob to setting
•
Check for tripped household circuit breakers or RCB Reset
or replace if necessary.
•
Try a known, working appliance in the outlet.
•
Try a different outlet, preferably on a different circuit.
•
Replace controller or heating element.
•
Turn controller to OFF position before plugging into electrical
outlet.
•
Do not use other electrical appliances on the same circuit.
•
Keep controller and all electrical connections dry. Do not
operate unit when raining.
•
Replace damaged controller or extension cord.
•
Close lid on barbecue while cooking.
•
Preheat 15-20 minutes. Increase controller setting.
•
Replace with appropriately rated cord (16 amps).
•
Clean lower porcelain bowl.
•
Trim fat from meat before barbecueing.
•
Adjust (lower) temperature as needed.
•
Clean barbecue.
•
Increase knob setting or wait for light to cycle on.
•
See "barbecue not heating".
•
Replace controller or heating element.
•
Turn controller knob to the
(OFF)position. Keep lid
closed and let fire burn out. After barbecue cools, clean the
fire bowl.
•
Do not apply water to fire. Personal injury may result.
.
C H A R B R O I L. E U