Installing The Leg Covers - Thermador PROFESSIONAL PRO GRAND PRD36 Manual De Instalación

Installing the Leg Covers

1. Remove plastic coverings of the stainless steel
'sleeves'.
2. Place the smaller 'sleeve', with cutouts facing up,
inside the larger sleeve with the openings of both
stacked and facing the back (Figure 26).
3. Beneath the range, wrap the mated pieces around the
leg.
4. Slide the outer sleeve up while the inner piece remains
on the floor. The mating part has dimples (that you
cannot see) for which the holes of the larger sleeve
should seize. You should feel a definitive click, letting
you know that the apparatus has been mounted to the
unit (Figure 27).
5. Repeat for all visible legs.
After the range is properly leveled and the leg covers have
been installed, replace the Door Trim and reinstall the
Oven Door(s) ("Step 4: Door Removal and Reinstallation"
on page 10 for door re-installation).
Figure 26: Leg Covers
Griddle Tilt Adjustment
Check the griddle adjustment by pouring two tablespoons
of water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the (2) screws
under the back of the griddle plate. Start with one half turn
counter-clockwise of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Ensure that the burner caps are correctly seated on the
burner bases of the range's cooktop.
Figure 27: Leg Covers Installed
(Not on all models)
English 27