EdilKamin ELLKAMIN 8 Instalación Uso Y Mantenimiento página 41

The insert is supplied with a base plate (A) complete with
smoke duct (B) and primary air duct (C).
The insert can be removed for loading pellets (OPERATION
TO BE PERFORMED WITH THE INSERT TURNED
OFF) and for any maintenance or cleaning by an Authorised
Technical Assistance Centre.
To fi t, proceed as follows:
• Check for a power outlet on the back of the insert, so that it is
accessible once installation is complete.
• After evaluating the proper position of the insert, lift it using
the two handles on the sides of the insert (D – Fig. 1), from the
base plate (A – Fig. 1).
• Secure the base plate (A – Fig. 2) on the base using bolts
through the holes positioned on the perimeter of the plate (X –
Fig. 5).
Alternatively, to secure the above plate, you can use the exist-
ing holes in the same base plate (Y – Fig. 5) and countersunk
screws (the screw head must not protrude more than 2 mm
from the base plate).
The customer can make other holes, being careful not to do so
in line with the guides
(Z – Fig. 5)
• Fit the fl ue (not supplied) on the smoke duct (B) and the Ø 40
mm tube (C1 – not supplied) on the primary air duct (C).
The Ø 40 mm tube (C1 – not supplied) can be installed from
below the base plate (A), see Fig. 3.
• Replace the insert (Fig. 4) by sliding it on the base plate (A
– Fig. 2) until it stops (the insert must fi t in the two slots (E –
Fig. 2) in the front part of the base plate (A – Fig. 2), taking
care that the power supply cord is not crushed between the two
plates.
X X
6,5
15
X
fi g. 5
INSTALLATION
X
X
Y
15 6,5
23
Z
fi g. 1
fi g. 2
E
fi g. 3
X
fi g. 4
- 41
-
B
C
A
D
B
C1
C
A
B
C
A
C1