Descargar Imprimir esta página

Progress Lighting AirPro P250104-31M-CS Manual De Instalación página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

Wiring the Receiver
to the Household
Wiring
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Connect the green wire to the household
ground wires using a wire connecting nut.
2. Connect the receiver black wire to
the household black wire using a wire
connecting nut.
3. Connect the receiver white wire to
the household white wire using a wire
connecting nut.
Wiring the Fan to the
Receiver
1. If using the 4.5 in. ball/downrod assembly
provided, wire the receiver to the fan wires
by connecting the molded adaptor plug from
this receiver with the molded adaptor of the
fan motor assembly together. (Figure 11)
2. If you wish to use longer downrod, you can
use the extension lead wire (66 in.) provided
by connecting the molded adaptors together.
USE
THE
PLASTIC
WIRE
SUPPLIED WITH YOUR FAN. SECURE THE
CONNECTORS WITH ELECTRICAL TAPE AND
ENSURE THERE ARE NO LOOSE STRANDS OR
CONNECTIONS.
EACH WIRE NUT (WIRE CONNECTOR) SUPPLIED
WITH THIS FAN IS DESIGNED TO ACCEPT UP TO
ONE 12 GAUGE HOUSE WIRE AND TWO WIRES
FROM THIS FAN. IF YOU HAVE LARGER THAN
12 GAUGE HOUSE WIRING OR MORE THAN
ONE HOUSE WIRE TO CONNECT TO THE FAN
WIRING, CONSULT AN ELECTRICIAN FOR THE
PROPER SIZE WIRE NUTS TO USE.
L N
BLACK
WHITE
Remote
Receiver
BLACK
BLUE
WHITE
BLACK
BLUE
WHITE
WHITE
BLUE
WHITE
BLACK
6. Making the Electrical Connections
Finishing the Fan
Installation
CONNECTORS
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling
canopy with the two screws in the
GREEN
mounting plate. Push up to engage the
MOUNTING
slots and turn clockwise to lock in place.
BRACKET
Immediately tighten the two mounting
GREEN
screws firmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws in
the canopy. Rotate the ring clockwise to
lock in place.
4. You may now proceed to attaching the
fan blades.
Figure 11

Publicidad

loading

Este manual también es adecuado para:

Airpro p250104Airpro p250104-009-cs