Stanley SL18701P-10A Manual De Usuario página 7

OPERATING INSTRUCTIONS
DRY PICK-UP DRY PICK-UP
The cartridge filter can be used for wet or dry pick up; installation is the same for both. When picking
up large quantities of liquid please refer to the Wet Pick UP Operation section in this manual. Use
the cartridge filter in position over the filter cage for most general dry material pick.
1. With the power head in an upside down postition, slide the cartridge filter down over the filter cage,
push the filter seals against the power head.
2. Place filter retainer into the top of the cartridge filter, hold the power head with one hand, turn the
handle on the filter retainer clockwise to tighten, locking the filter into place.
3. To remove the cartridge filter for cleaning, again hold the power head and turn the filter retainer
counter-clockwise to loosen and remove, slide the cartridge filter off the filter cage.
4. To clean the cartridge filter shake or brush off excess dirt or rinse(from the inside of the filter) with
water, dry completely (approximately 24 hours) and re-install.
NOTE: If the filter has been used for wet pick up, it must b cleaned and dried before using for
dry pick up.
5. Slide collar of filter bag into retainer guides.
6. When secured in place, expand bag and position around the inside of the tank.
Lock
Unlock
3
7