Publicidad
Idiomas disponibles
Idiomas disponibles
To Stop the Chain Saw
1. Move the chain saw away from cutting area and release the trigger switch to stop
the chain saw.
2. Push the chain kickback brake handle forward to the brake position to engage the
chain brake (Fig. 6).
WARNING:
breaks and after finishing work.
PREPARATION FOR CUTTING
Refer to "Important Safety Instructions" earlier in this manual for appropriate safety
equipment.
Work Area Precautions
Cut only wood or materials made from wood; do not cut sheet metal, plastics,
masonry, or non-wood building materials.
Never allow children to operate the chain saw.
Allow no person to use this chain saw who has not read this Operating Manual or
received adequate instructions for the safe and proper use of this chain saw.
When felling a tree, keep everyone - helpers, bystanders, children, and animals -
a safe distance from the cutting area. During felling operations, the safe distance
should be a least twice the height of the largest trees in the felling area. During
bucking operations, keep a minimum distance of 15 feet (4.5 m) between
workers. Trees should not be felled in a manner that would endanger any person,
strike any utility line or cause any property damage. If a tree does make contact
with any utility line, the utility company should be notified immediately.
Always cut with both feet on solid ground to prevent being pulled off balance.
Do not cut above chest height, as a saw held higher is difficult to control against
kickback forces.
Do not fell trees near electrical wires or buildings.
Cut only when visibility and light are adequate for you to see clearly.
30
56V LITHIUM-ION CORDLESS CHAIN SAW
Always remove the battery pack from the chain saw during work
Publicidad
