Descargar Imprimir esta página

Ego Power+ CS1400 Manual De Operación página 36

Ocultar thumbs Ver también para CS1400:

Publicidad

Idiomas disponibles

Idiomas disponibles

When the log is supported on both
ends, cut 1/3 of that diameter
from the top overbuck. Then make
the finished cut by underbucking
the lower 2/3 to meet the first cut
(Fig. 27).
When bucking on a slope, always
stand on the uphill side of the log
(Fig. 28).
To maintain complete control when
cutting through, release the cutting
pressure near the end of the cut
without relaxing the grip on the
chain saw handles. Don't allow the
chain to contact the ground. After
completing the cut, wait for the saw
chain to stop before you move the
chain saw. Always stop the motor
before moving from tree to tree.
36
56V LITHIUM-ION CORDLESS CHAIN SAW
27
Log Supported Both Ends
1st Cut Overbuck (1/3 Diameter) to Avoid
Splintering
2nd Cut Underbuck (2/3 Diameter) to Meet 1st Cut
(To Avoid Pinching)
28

Publicidad

loading