Paslode PS225C Manual De Funcionamiento Y Esquema página 6

TOOL OPERATION -
continued
Note:
Follow the siding manufacturer's instructions
when installing the nails. Always use the nail
size specified by the siding manufacturer
and/or the local building codes.
Use only fasteners that meet Paslode
Use of fasteners that do not meet Paslode
tions can result in damage to the tool or injury to the
operator or bystanders.
Driving of Nails
Precision Placement Driving - (Orange Trigger)
Grasp the tool handle firmly and hold the bottom of the
■
■
work contacting element firmly against the workpiece until
it is completely depressed.
Squeeze the trigger to drive the fastener.
■
Lift the tool from the workpiece.
■
Repeat the procedure for the next fastener.
■
WARNING
specifications.
®
specifica-
®
Successive (Bounce) Driving - (Orange Trigger)
Grasp the handle firmly.
■
Squeeze the trigger and move the tool along the work-
■
piece with a bouncing motion, depressing the work con-
tacting element at the points where you want to insert a
fastener.
Keep the trigger depressed and continue to bounce the
■
work contacing element against the workpiece, positioning
the tool above as carefully as possible.
When the desired number of fasteners have been driven,
■
release the tool trigger to avoid unintentional fastener dis-
charge.
Sequential Operation - (Gray Trigger)
The sequential operating kit prevents successive or
"bounce" driving.
Depress the work contacting element and hold it against
■
the work surface before pulling the trigger.
After each fastener is driven, completely release the trig-
■
ger and lift the tool from the work surface.
6