Publicidad
Idiomas disponibles
Idiomas disponibles
14
Oval Radiant Tube Heaters
Installing Reflectors & Supports
Refer to Fig. 8 and the following instructions:
1. Slide the reflector through the hangers until it is
about 1 or 2 inches away from the burner box.
2. Using 4 U-clips, attach the end cap to the end of
this reflector. Push this reflector up to burner box.
FIG. 8
FLANGE
DOTTED LINES: INDICATE
CONNECTOR WITHIN FOLDED
Owner's Manual • Oval Radiant Tube Heaters
CONNECTOR STRIP
(DIMPLES UP)
CONNECTION STRIPS:
• Insert a connection strip halfway
into the folded channel at both
CHANNEL
sides of a reflector, at the end
without flanges.
• Slide this end of the reflector
through the hanger and push it
firmly into the folded channels of
the reflector at the burner box.
REFLECTOR END VIEW
SHOWING FOLDED
• The unflanged end of the reflector
CHANNEL
will overlap the flanged end of the
adjacent reflector.
3. Connect the second reflector to the end of the
first reflector with the dimpled connector strips.
See Fig. 8 below.
4. Attach remaining end cap to last reflector with
4 U-clips.
Publicidad
