GASPARDO FIORE Empleo Y Mantenimiento página 49

Danger of getting squashed. Keep well away from the machine
while it operates.
move the mower's blandes for some minutes to remove the
protective paint on the blandes.
safety tie rod parallel to the ground, and reverse the tractor
until the safety tie rod hooks up again.
ATTENTION
A spring compression other than that indicated in Figure 30 (15
mm) can make the safety device ineffective.
Set and maintain the power take-off at a constant rate of 540
rpm to ensure correct blade frequency maintain an engine
speed of 1800÷2000 rpm.
In case of breakages, damage or other inconveniences, stop
the machine immediately. Always work in complete safety.
If the blades become jammed, it is advisable to intervene
carefully wearing suitable personal protection gear.
All the maintenance, adjustment and work preparation ope-
rations, must be carried out with the tractor strictly switched
off and properly stationary, with the ignition key out and the
planter on the ground.
- Always raise the implement in order to reverse or change
direction.
- The cutting arm should not be raised abruptly in order to
avoid damaging the cutting blades.
- Do not work whit P.T.O. in synchronism with the wheels.
- Power take-off must not exceed 540 r.p.m.
- Never run the motor at maximum power while mowing.
- In order to prevent breakages or damage, the speed of the
tractor must never exceed 10 Km/hour when the implement
is working.
The mowing machine has sharp cutting blades. Always make
sure that there are no person, chidren, domestic animals,
of the implement.
cod. G19503900
DANGER
Position the
CAUTION
DANGER
USE AND MAINTENANCE
Fig. 29
Fig. 30
W
Fig. 31
Caution when turning on slopes
HAZARD BAR
A
T
U
V
Z
ENGLISH
49