Ryobi RY3714VNM Manual Del Operador página 34

CLEANING THE STARTER ASSEMBLY
See Figure 61.
Use a brush or compressed air to keep the cooling
vents of the starter assembly free and clean of
debris.
CLEANING THE ENGINE
See Figures 62 - 63.
Clean the cylinder fins and flywheel fins with com-
pressed air periodically. Dangerous overheating
of the engine may occur due to impurities on the
cylinder.
WARNING:
Never run the saw without all the parts, including
the clutch cover and starter housing, securely
in place. Operating the saw without all parts
securely in place can result in death or serious
personal injury.
Because parts can fracture and pose a danger
of thrown objects, leave repairs of the flywheel
and clutch to factory trained qualified service
center personnel.
NOTE: If you notice a power loss with the gas-
powered tool, the exhaust port and muffler may
be blocked with carbon deposits. These deposits
may need to be removed to restore performance.
CHECKING THE FUEL FILTER
See Figure 64.
Check the fuel filter periodically. Replace it if
contaminated or damaged.
REPLACING THE SPARK PLUG
See Figure 65.
This engine uses a Bosch WSR6F or Torch L7RTC
spark plug with .025 in. (0,64 mm) electrode gap.
Use an exact replacement and replace every 50
hours or more frequently, if necessary.
NOTICE:
Allow engine to cool before removing spark
plug. Removing spark plug from a hot engine
can cause serious damage to the chain saw.
 Remove the air filter cover as described in
Cleaning the Air Filter earlier in this manual.
MAINTENANCE
OF CYLINDER
COVER SCREWS
 Loosen the spark plug by turning it counter-
clockwise with a wrench.
 Remove the spark plug.
 Hand thread the new spark plug, turning it
clockwise. Tighten securely with wrench.
Page 34 — English
CLEAN FLYWHEEL
FINS
1
2
LOCATION
Fig. 61
4
3
Fig. 62