Taurus GUZZLER CYCLONE Instrucciones De Uso página 7

Unplug the appliance from the mains.
Retract the cable by pressing the roller cable
button and guide the cable into the appliance
(H).
The cable housing means you can remove and
have available the required length of cable for
working with the appliance, preventing accident
risk situations.
Clean the appliance.
CARRY HANDLE/S:
This appliance has a handle on the upper
part of the body, which facilitates comfortable
transportation (L).
PARKING POSITION:
This appliance has its own parking position for
comfortable and straightforward storage.
To make use of the horizontal parking hook the
head's hook onto the hook that is to be found
on the lower part of the appliance (Fig.3).
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
Empty the dust container after each use of the
vacuum cleaner.
Disconnect the hose from the vacuum cleaners
air intake. (Fig.2)
Disconnect the dust box from the appliance
(Fig.4).
Remove the tank lid by operating the lever (Q)
and pour the contents into a suitable waste
container (Fig. 5).
Check the condition of the filters.
Attach the tank lid.
Attach the dust box to the appliance.
Connect the hose to the vacuum cleaners air
intake. (Fig.1)
CHANGING THE FILTERS:
Inlet filter:
It is advisable to be changed at least once a
year or every 50 hours of the appliance's use.
Outlet filter:
HEPA filter (high efficiency air filter that
efficiently retains spores, ash, sawdust,
pollen...), it is advisable to change it a least
once a year or after every 50 hours of use.
NOTE: If a significant decrease in suction of
the device is observed, the filters must be
changed.
TO REMOVE THE FILTERS:
Inlet filter:
Detach the dust container (Fig.4).
Remove the mycofibre filter using the filter's
central clips (Fig.6).
Remove the sponge filter.
Outlet filter:
Open the air outlet filter grille. To access the
HEPA filter (Fig.7).
Remove the HEPA filter by pressing the
release clip on the top.
To reassemble the filter, proceed with the
above instructions, in reverse order.
SUPPLIES
Supplies can be acquired from distributors
and authorised establishments (such as filters,
etc...) for your appliance model.
Always use original supplies, designed
specifically for your appliance model.