Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
the device by the cutting blade.
Contact with the cutting blade can lead
to injuries.
• Do not use the device near
flammable liquids or gases. In
the event of a short circuit there is a risk
of fire and explosion.
• The blades must be checked
regularly for wear and re-
ground. Blunt blades overload the
device. Any damage that results is not
covered by the warranty.
• Do not try to repair the device
by yourself unless you have
professional training. All work
not mentioned in this instruction
manual may only be performed
by our service centre. Many acci-
dents are caused by poorly maintained
appliances.
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Eye damage if no suitable eye protec-
tion is worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Cutting injuries
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
34
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Wall bracket
You can hang the motor part on the wall
with the keyhole (23) on the bottom of the
device.
Tools and aids required
• Screw (screw head: ⌀ 8-10 mm)
• Corresponding screwdriver
• Dowels, if necessary
Attaching the wall bracket
WARNING! Personal injury or dam-
age to property during drilling. Use suit-
able detectors to determine if
there are hidden supply lines or
contact the local utility company
for assistance. Contact with electric
cables can cause fire and electric shock.
Damaging gas lines can lead to explo-
sion. Breaking water pipes causes prop-
erty damage.
• Using dowels, place one screw at the
desired position on a wall.
• Let the screw head protrude with ca.
10 mm mm distance to the wall.
• Make sure that the suspension system is
designed for the weight of the device.
• (Fig. D) You can place the device with
the keyhole (23) against the screw and
Publicidad
