Publicidad
EN
effective protection against intrusion. If effective
protection is required, the automation system must
be combined with other devices;
the product may not be used until the automation
system "commissioning" procedure has been
performed as specified in the "Automation system
testing and commissioning" section;
the system power supply line must include a
circuit breaker device with a contact gap allowing
complete disconnection in the conditions specified
by class III overvoltage;
use unions with IP55 or higher protection when
connecting hoses, pipes or cable glands;
the electrical system upstream of the automation
system must comply with the relevant regulations
and be constructed to good workmanship
standards;
this appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved;
before starting the automation system, ensure that
there is no-one in the immediate vicinity;
before proceeding with any cleaning or maintenance
work on the automation system, disconnect it from
the electrical mains;
special care must be taken to avoid crushing
between the part operated by the automation
system and any fixed parts around it;
children must be supervised to ensure that they do
not play with the equipment;
drive is not to be used with doors having openings
exceeding 50mm in diameter or having edges or
protruding parts a person could grip or stand on;
that the drive cannot be used with a driven part
incorporating a wicket door unless the drive can
only be operated with the wicket door in the safe
position;
in the case of detection of an obstacle during its
closing travel, the garage door reverses its travel
direction, releasing the obstacle until it opens
completely;
install the actuating member for the manual
release at a height less than 1,8m. If removable,
the actuating member should be stored in direct
4
vicinity of the door;
install any fixed control at a height of at least 1,5m
and within sight of the door but away from moving
parts;
permanently fix the labels warning against
entrapment in a prominent place or near any fixed
controls (Fig. 1 Pag. 54);
after installation, ensure that the mechanism is
properly adjusted and that the drive reverses or
the object can be freed when the door contacts a
50mm high object placed on the floor (for drives
incorporating an entrapment protection system
depending on contact with the bottom edge of the
door);
after installation, ensure that parts of the door do
not extend over public footpaths or roads;
when the appliance is provided with a separate stop
button, that stop button shall be unambiguously
identifiable.
ATTENTION !
Frequently
examine
imbalance where applicable and signs of wear
or damage to cables, springs and mounting.
Do not use if repair or adjustment is necessary.
ATTENTION !
Packaging components (cardboard, plastic,
etc.), duly separated, must be placed in the
appropriate bins. Device components such as
electronic boards, metal parts, batteries, etc.
must be separated and differentiated. For the
methods of disposal, the rules in force in the
place of installation must be applied. DO NOT
DISPOSE IN THE ENVIRONMENT!
Key Automation reserves the right to amend
these instructions if necessary; they and/or
any more recent versions are available at www.
keyautomation.com
the
installation
for
Publicidad
